Furnace Repair & Heating Service in Edmond, OK
Furnace repair and heating service in Edmond, OK (73003, 73012, 73013, 73034, 73025): older UCO-area homes to zoned systems in Oak Tree and Gaillardia.
Who provides furnace repair and heating service in Edmond, OK?
Graco is based in Edmond and handles furnace repair, heat pump service and full system replacement in every Edmond ZIP code: 73003, 73012, 73013, 73034 and 73025. Our licensed HVAC technicians work 24/7, quote flat-rate pricing before starting, and run a carbon-monoxide safety check on every furnace visit. Call (405) 500-5333 for heating service anywhere in Edmond.
Edmond grew outward from the Downtown Edmond and UCO core in waves, and each wave built houses differently. A 1950s bungalow off 2nd St and a 2015 two-story off Covell Rd have almost nothing in common mechanically. Here is how that plays out when the heat goes out.
Edmond neighborhoods by era, and what that means for your furnace
Downtown Edmond, Broadway and the UCO core (pre-1960s)
The oldest part of town, around Downtown Edmond, Broadway and the University of Central Oklahoma, has homes that predate central heat. We still find:
- Floor furnaces or wall heaters, sometimes as the only heat source in part of the house
- Gas furnaces installed in closets or crawlspaces decades after construction
- Patched or shared venting that needs checking before any new equipment goes in
- Older homes converted to rentals near UCO, where the furnace has been repaired many times instead of replaced
Safety is the priority on these calls. Old gas heaters and retrofit venting are where carbon monoxide problems start.
Kickingbird Estates, Fairfax and the 1970s–80s rings
As Edmond expanded in the 1970s and 1980s, neighborhoods like Kickingbird Estates and the established areas off Danforth and Santa Fe Ave filled in with single-story and split-level homes. Many still have an 80% efficiency gas furnace in a garage or utility closet, and many of those furnaces are on their second or third replacement cycle, with the current one now 15 to 25 years old.
This is where most of our Edmond repair-versus-replace decisions happen. Typical findings:
- Cracked heat exchangers on furnaces 20 years or older
- Inducer motors and igniters that fail on the first cold night
- Metal flues and ducts that are original to the house
If yours is in that age range, our article on whether it’s worth fixing a 20-year-old furnace lays out the trade-offs.
Oak Tree and the large-home golf communities (1980s onward)
Oak Tree, and later golf-course communities such as Gaillardia and Fairway Estates, brought larger homes with higher ceilings and more square footage. These homes commonly have two systems or a single system with zoning. The furnace might be in the attic, a mechanical closet, or both.
Problems here are less about the furnace burning gas and more about distributing heat:
- Zone dampers stuck open or closed
- Zone control boards and thermostats that stop communicating
- One system overworked because the other failed quietly in the fall
We cover this in detail in zoned heating for large Edmond homes.
Coffee Creek, Iron Horse Ranch, The Territories, Spring Creek and the Covell corridor (1990s–2010s)
North and west Edmond grew fastest from the 1990s on: Coffee Creek, Iron Horse Ranch, The Territories, Spring Creek, Covell Ranch and the subdivisions along the Covell Rd corridor. These homes almost always have attic-mounted furnaces, frequently high-efficiency condensing models with two PVC vent pipes.
The first-generation builder furnaces from the late 1990s and 2000s are now aging out. What we see most:
- Clogged or frozen condensate lines that shut the furnace off
- Pressure switch faults from blocked or iced-over PVC vents
- Flex duct that has sagged or separated in the attic
- Builder-grade equipment reaching 15 to 20 years
Our guide to attic furnace problems in Oklahoma explains what you can safely check from the attic hatch.
Oakdale, Arcadia Lake and acreage homes
Toward the edges of 73025 and 73034, around Oakdale and out toward Arcadia Lake, there are more homes on acreage. Some have natural gas, some run on propane, and some rely on heat pumps with electric backup. Heat pump owners should know how emergency heat works before a deep freeze, since running on electric strip heat for days is expensive.
Edmond ZIP codes at a glance
| ZIP | General area | Typical heating setup | What we see most |
|---|---|---|---|
| 73034 | Downtown Edmond, UCO, east Edmond toward Arcadia Lake | Mix of old closet furnaces, floor furnaces, and newer attic units on the east side | Venting and CO concerns in older homes; attic condensate on newer ones |
| 73003 | West-central Edmond, Kickingbird Estates, Santa Fe Ave and Danforth | 1970s–90s gas furnaces in garages and closets | End-of-life furnaces, heat exchanger cracks |
| 73013 | South Edmond toward Memorial and the Kilpatrick Turnpike | 1980s–2000s homes, closet and attic furnaces | Igniter and inducer failures, duct leaks |
| 73012 | Northwest Edmond, Covell Rd corridor, newer subdivisions | Attic condensing furnaces, some zoning | Condensate clogs, pressure switch faults |
| 73025 | North Edmond, Oak Tree, acreage areas | Large-home zoned systems; propane or heat pumps on acreage | Zone control faults, two-system imbalance |
For the rest of the metro, our furnace and heating service by ZIP code guide covers NW OKC, Yukon and Mustang.
Edmond winter conditions that stress furnaces
Edmond’s heating season is short but uneven. The first cold front usually lands in late October or November, and furnaces that have not run since spring tend to fail that week. Days can swing 30 degrees or more between afternoon and night, so a system that seems fine at 4 p.m. may not keep up at 4 a.m.
Ice storms and multi-day freezes are the real test. During the February 2021 deep freeze, attic furnaces in newer Edmond subdivisions shut down when condensate lines froze, and older furnaces ran nonstop until something gave. A furnace tune-up in Edmond before November catches the weak igniter, dirty flame sensor or partly clogged drain that would otherwise fail on the coldest night.
Repair or replace in Edmond?
We quote the repair first, at a flat rate, before any work starts. When a furnace is past 15 to 20 years, has a cracked heat exchanger, or needs a part that is no longer made, we also show you what replacement would involve so you can compare. In large homes with two systems, it often makes sense to plan both replacements together rather than wait for the second one to fail in January. In older homes near Downtown Edmond, replacement is also the moment to correct venting, return air and duct sizing that were never designed for modern equipment.
Safety first
If your carbon monoxide alarm goes off or you smell gas, leave the house immediately. Call 911 or Oklahoma Natural Gas from outside. Do not reset the furnace, flip breakers repeatedly or try to relight a pilot.
Get heating help in Edmond
Edmond is home base for Graco, so we know these neighborhoods street by street. Call (405) 500-5333 any time, or start with furnace repair in Edmond or furnace installation in Edmond.
Frequently asked questions
- Who repairs furnaces in Edmond, OK?
- Graco is based in Edmond and repairs, maintains and replaces furnaces and heat pumps across all five Edmond ZIP codes: 73003, 73012, 73013, 73034 and 73025. We are veteran-owned, available 24/7, and quote flat-rate pricing before any work starts. Call (405) 500-5333.
- Why does only one floor of my Edmond house stay cold?
- In large two-story homes, one furnace often struggles to heat both floors evenly, and heat rises to the upstairs while the downstairs stays cool. Many homes around Oak Tree, Gaillardia and Iron Horse Ranch have zoned systems or two separate systems for this reason. A stuck zone damper, a failed zone control board or a thermostat problem on one zone are common causes we diagnose.
- Do older homes near Downtown Edmond and UCO need special heating service?
- Older homes near Downtown Edmond, Broadway and UCO can have floor furnaces, wall heaters, or a furnace added long after the house was built. Those setups need careful attention to venting and combustion air. Every Graco furnace visit includes a carbon-monoxide safety check.
- What if my Edmond home is on acreage outside town?
- Some homes in the 73025 and 73034 areas, especially on acreage, may run on propane or rely on a heat pump instead of natural gas. We service both, and the right equipment depends on fuel availability at your property. We will tell you what makes sense rather than defaulting to one system.
- When should I schedule a furnace tune-up in Edmond?
- Ideally in September or October, before the first cold snap that usually arrives in late October or November. That gives time to fix a weak igniter, dirty flame sensor or clogged attic condensate line before you need heat every night. Members of our maintenance plan get scheduled reminders.